Trading hours:Mon - Fri 7.30AM - 5:00PM VIC: +61 3 9429 9111NSW:+61 2 9817 4441
Cementitious Repair

Pavepatch F

Pavepatch F content


  • High strength, hard wearing and impact resistant
  • No metallic iron content to cause staining or disruptive expansion
  • Low Shrinkage
  • Integral bond with the base concrete
  • High ultimate strength and low permeability ensure the durability and resistance to oil, grease and water

Typical Properties
Compressive Strength @25OC
4 Hours – 23 MPa
24 Hours – 37 MPa
7 Days – 52 MPa
28 Days – 60 MPa
Initial Set – 35 minutes
Trafficable – 1 hours
Vehicle traffic – 4 hours

Prime the concrete with Renderprime just prior to commencing the repairs. Apply the primer with a roller, broom or spray to give an even film over the surface. Porous concrete may require priming a second time to seal the

Add the required mixing water (1.8 – 2.0 lt) to the mixer and slowly introduce the Pavepatch D while mixing. Mix for 3 – 4 minutes using a forced action mixer suitable for mortars.

Screed the freshly mixed mortar over the primed floor to give the required levels or falls. Compact the mortar using a wooden float, and finish to the required standard using either a float or steel trowel.
Ensure a constant supply of freshly mixed   Pavepatch D to ensure continuity in the screed.

Always read the product data sheet, MSDS and product label prior to use of this material.